Stinky bladders, I'm sure theres a joke in that statement but I'll let you fill in the blanks.
Parts needed.
1/2" PVC pipe. 2 One foot sections and 1 18-24" section. Two 6" sections
Two 1/2" PVC Tee's
Two 1/2" 90 degree elbows.
As you can see by not putting glue on the pieces its adjustable and can collapse into a straight line. I made this guy up after having some water leftover and getting a skunky tasting water. Haven't had any trouble since its creation, just pull off the bite valve and slide the long piece into the fill hole and setup an angle, the 1/2 inch long leg keeps the bladder from closing down on itself and sealing the water between the sides of the bladder.
No comments:
Post a Comment